Anagram & Information om | Engelska ordet CLAMPED

Exempel på hur man kan använda CLAMPED i en mening

• Central Trains also clamped down on vandalism on its trains and fare evasion, including through a controversial poster campaign publicising the names and addresses of passengers who had been fined for not having valid tickets.
• This device clamped onto and "bit" into the cable (hence the name "vampire"), inserting a probe through a hole drilled using a special tool through the outer shielding to contact the inner conductor, while other spikes bit into the outer conductor.
• This culminated in Boothroyd threatening to have Clwyd's car clamped if she did it in future whereupon Clwyd desisted.
• The daxophone consists of a wooden piece called a tongue, approximately 330 mm in length, 30 mm in width, and 5 mm in height, and fixed to a wooden block (often attached to a tripod, but also clamped to a table top), which holds one or more contact microphones.
• The tongue is then clamped with forceps, and pierced with a needle, usually from top to bottom with a piercing needle or from bottom to top with a cannula needle.
• In typical laboratory operation, such as distillation, the condenser is clamped to a retort stand in vertical or oblique orientation.
• Standard diving dress consists of a diving helmet made from copper and brass or bronze, clamped over a watertight gasket to a waterproofed canvas suit, an air hose from a surface-supplied manually operated pump or low pressure breathing air compressor, a diving knife, and weights to counteract buoyancy, generally on the chest, back and shoes.
• Once on orbit and clamped to the host spacecraft, the PECs are opened and serve as racks to expose experiments to the space environment.
• The logo represents the first vibrational mode of a thin L-shaped membrane, clamped at the edges, and governed by the wave equation, which was the subject of Moler's thesis.
• Veteran Hollywood portraitist George Hurrell was hired to shoot Waits, both alone and in a clutch with a shadowy female whose ring-encrusted right hand clamped a passport to his chest.
• At first rejected by the whaler that landed on his island, he skillfully jumped from a canoe and clamped to the side of the boat as it was leaving for the open sea, at which point the captain relented.
• A clasping or clamped buttress has an L-shaped ground plan surrounding the corner, an angled buttress has two buttresses meeting at the corner, a setback buttress is similar to an angled buttress but the buttresses are set back from the corner, and a diagonal (or 'French') buttress bisects the angle between the walls where they meet.
• This control cable had been clamped to compensate for its greater length, but when the vehicle lifted off, the clamping did not work as planned and the control cable separation was delayed, eventually occurring about 29 milliseconds after the power cable had separated.
• In both the preloaded tension and slip-resistant shear joints, some level of preload in the bolt and resulting compression in the clamped components is essential to the joint integrity.
• In books of collected journalism such as Der rasende Reporter (The Whirling Reporter) (1924), he cultivated the image of a witty, gritty, daring reporter always on the move, a cigarette clamped doggedly between his lips.
• always shoeless, often shirt-less, resin-stained Levis clamped onto his nonexistent hips with a length of rope, stringy blonde hair cut straight across at eyebrow level and flapping down over his ears.
• The end of the pressure rod was clamped across the strings between the guitar's bridge and tailpiece assemblies.
• It has roll and yaw data derived from a modified AN5735-1 Direction Indicator and AN5736-1 Gyro Horizon, boosted by a piggyback amplifier on the direction indicator driving a Globe Motors bi-directional motor/servo clamped to the top of the control column via the aileron control chains.
• On original 10BASE5 (thicknet) Ethernet equipment, the MAU was typically clamped to the Ethernet wire via a vampire tap and connected by a multi-wire cable to the computer via a DA-15 port, which was also present on the network interface controller (NIC).
• A more recent innovation is the horizontal mortiser, which incorporates a router mounted statically on its side with the workpiece clamped to a multi-axis sliding table.

Förberedelsen av sidan tog: 619,85 ms.