Definition & Betydelse | Engelska ordet PHOTODIODE

Definition av PHOTODIODE

1. fotodiod

Exempel på hur man kan använda PHOTODIODE i en mening

• Photocurrent is the electric current through a photosensitive device, such as a photodiode, as the result of exposure to radiant power.
• The FM3ᴀ's metering information system consisted of a match-needle system using two needles pointing along a vertical shutter speed scale on the left side of the viewfinder to indicate the readings of the built-in 60/40% centerweighted silicon photodiode light meter versus the actual camera settings.
• To offset this drop in signal after the pinhole, the light intensity is detected by a sensitive detector, usually a photomultiplier tube (PMT) or avalanche photodiode, transforming the light signal into an electrical one.
• An avalanche photodiode (APD) is a highly sensitive type of photodiode, which in general are semiconductor diodes that convert light into electricity via interband excitation coupled with impact ionization.
• A monaxial holographic lens collects the wave front and reconstructs the pattern onto the single dimensional photodiode array and a two dimensional matrix sensor.
• It consists of a scintillator which generates photons in response to incident radiation, a sensitive photodetector (usually a photomultiplier tube (PMT), a charge-coupled device (CCD) camera, or a photodiode), which converts the light to an electrical signal and electronics to process this signal.
• Not only the output of the main photodiode is registered, but also the output of a number of secondary sensors, for example photodiodes that measure auxiliary laser beams, microphones, seismometers, accelerometers, magnetometers and the performance of all the control circuits.
• A single-photon avalanche diode (SPAD), also called Geiger-mode avalanche photodiode (G-APD or GM-APD) is a solid-state photodetector within the same family as photodiodes and avalanche photodiodes (APDs), while also being fundamentally linked with basic diode behaviours.
• Opto-isolator, opto-coupler, photo-coupler – photodiode, BJT, JFET, SCR, TRIAC, zero-crossing TRIAC, open collector IC, CMOS IC, solid state relay (SSR).
• One of the advantages of using a Nipkow disk is that the image sensor (that is, the device converting light to electric signals) can be as simple as a single photocell or photodiode, since at each instant only a very small area is visible through the disk (and viewport), and so decomposing an image into lines is done almost by itself with little need for scanline timing, and very high scanline resolution.
• A photoelectric, or optical smoke detector, contains a source of infrared, visible, or ultraviolet light—typically an incandescent light bulb or light-emitting diode (LED)—a lens, and a photoelectric receiver—typically a photodiode.
• The emission is also either passed through a filter or a monochromator before being detected by a photomultiplier tube, photodiode, or charge-coupled device detector.
• A scintillation detector or scintillation counter is obtained when a scintillator is coupled to an electronic light sensor such as a photomultiplier tube (PMT), photodiode, or silicon photomultiplier.
• In practice, the color attributes of each output pixel using this sensor result from the camera's image processing algorithms, which use a matrix process to construct a single RGB color from all the data sensed by the photodiode stack.
• This light is collected by the same objective and, because it is red-shifted with respect to the excitation light it passes the dichroic mirror reaching a detector, typically a photomultiplier tube, an avalanche photodiode detector or a superconducting nanowire single-photon detector.
• A photodiode is a semiconductor diode sensitive to photon radiation, such as visible light, infrared or ultraviolet radiation, X-rays and gamma rays.
• Before the pulse reaches the sample, some of the light is reflected by a dichroic mirror and gets detected by a photodiode that activates a delay generator controlling a gated optical intensifier (GOI) that sits in front of the CCD detector.
• After passing through the sample, the unabsorbed probe light continues to a photodetector such as an avalanche photodiode array or CMOS camera, and the data is processed to generate an absorption spectrum of the excited state.
• As the gravitational wave passes, it alters the path of the two beams differently; they are then recombined, and the resulting interferometric pattern is measured with a photodiode.
• The DP-3 introduced three innovations: a silicon photodiode light meter (a first for Nikon SLRs) for faster and more accurate light readings, a five-stage center-the-LED exposure control system using +/o/− LEDs, and an eyepiece blind.

Förberedelsen av sidan tog: 987,40 ms.